Assembleon Topaz X

Subscribe to Thread

We bought a used 1999 topaz x and are trying to get it up an... - Oct 06, 2012 by chrisims

Dear Chris, N2324 and N2325 are for nozzle down sensors. ... - Oct 08, 2012 by Vinit

chrisims

#67448

Assembleon Topaz X | 6 October, 2012

We bought a used 1999 topaz x and are trying to get it up and running. unfortunately we are getting an error: Anyone know where i can get a service manual or having any idea where to look to resolve this problem?

"E229" “Nozzle down limit sensor is off” “please check the sensor and remove the cause of this sensor being off” Machine: Sensor NO: YV100X N2325

Thank You, Chris

reply »

Vinit

#67451

Assembleon Topaz X | 8 October, 2012

Dear Chris,

N2324 and N2325 are for nozzle down sensors. THese sensors are located on the left and right side of the left and right walls of the head assembly respectively. There are very small holes in the walles through which these sensors transmit and receive the beams. THe procedure is the open the front cover the of head assembly, clean these 3 tiny holes (in an traingular pattern) using air. You can use a sharp pin to clean the hole to but be very careful not to damage the sensors.

If the holes are partially blocked then you can adjust the senstivity of the sensors using the potentiometers on the cable. The cable is on top of the head assembly (green colored potentiometers).

Hope this helps.

Vinit

reply »