Connector

Connector | 27 February, 2012

Could anyone suggest where I could get a suitable connector for the 3pin oxggen sensor in the attached datasheet? It cannot be soldered.

The link in the datasheet to their recommended connector is broken.

I want to use a thru hole to mount it. I realise this is a SMT forum, so apologies!

Graeme

Attachments:

Connector | 2 March, 2012

21. What is the recommended way to connect the sensor?

Answer (Pellistors) For VQ500 series sensors please use sockets http://www.cambion.co.uk/Catalogue/Parts/1813.htm. For other pellistors connect to header legs by soldering or mechanical methods

Answer (Infrared) See datasheets for pin out connections . See http://www.cambion.co.uk/Catalogue/Parts/1813.htm for recommended sockets.

Answer (Electrochemical) Refer to datasheet for pin out connections. See http://www.cambion.co.uk/Catalogue/Parts/1813.htm for recommended sockets

Answer (Semiconductor) For TO39 sensors use sockets or solder to board. For SMD solder direct to board.

Now Online

41
Visitors

3
Members