Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Nozzle errors

Views: 3473

#64995

Nozzle errors | 11 September, 2011

We are using Fuji CP iv-3 and keep getting "Nozzle size alarm and Nozzle position error." I was wondering what is wrong and how do I fix these errors?

Thanks

reply »


SME

#64996

Nozzle errors | 11 September, 2011

> We are using Fuji CP iv-3 and keep getting > "Nozzle size alarm and Nozzle position error." I > was wondering what is wrong and how do I fix > these errors? > > Thanks

> We are using Fuji CP iv-3 and keep getting > "Nozzle size alarm and Nozzle position error." I > was wondering what is wrong and how do I fix > these errors? > > Thanks

Hi Do you get this error often, random during operation or at 1 certain position end or start of program, are the nozzle holders out of position(unlocked)? nozzle position seems to sugest they are but could also be caused by chips between nozzle shaft & holder number of reasons 1.Sensors position & alignment, reflective sticker condition or sensitivity 2.changer up/down (underneath nozzle holder) compression spring condition or height adjustment also updown operation 3.changer stopper adjustment & Rotary cylinder condition late or miss operation 4.rotary Cylinder operation(up/dwn) s-m /s-l etc position 5.cam Followers note.if you can't identify where the error is occurring slow machine down temporally to help you identify the error then return to 100% after correction

reply »

Solder Paste Dispensing

Facility Closure