QP 242

Dear All,

Thank you so much for your cooperation.

Actually am in continous problems with my BGA and can not assemble it using my QP242 till now, I am using the following data : Vision no. : 1 Vision Type: 230 Height: 2.32 Body Size X: 27.00 +-0.2 Body Size Y: 27.00 +-0.2 Check Window Area (Lead Check Area): 50% Pitch Limit: 30% Check Limit: 90% vision camera no : Rear vision size : Normal Scan Area X : 50 mm Scan Area Y : 50 mm Tolerance Pickup X: 0.0 Tolerance Pickup Y: 0.0 Tolerance Q : 1 degree Auto Offset : Yes Use P Pattern # 2 Result : 1 and 128 for the matrix. Width: 0.6 Length: 0.0 Pitch : 1.0 Lighting: 1 (frontlight A)

By using these data we get error (1CA00001) after checking for all balls in BGA .

and We use the following data :

Vision no. : 1 Vision Type:254 Height: 2.32 Body Size X: 27.00 +-0.2 Body Size Y: 27.00 +-0.2 Check Window Area (Lead Check Area): 50% Check Limit: 30% vision camera no : Rear vision size : Normal Scan Area X : 90 mm Scan Area Y : 90 mm Tolerance Q : 1 degree Lighting: 1 (frontlight A)

But we get error (1CAFE011)

When we use Vision Type:235 or 236 we get error (1CAEC042) once we send the program to QP242 M/C. So we can't use these vision types.

note :

when the machine boots,we checked the version on the lower monitor on the machine it was (FUJI MACHINE VERSION : 3.03)

We checked the machine version top screen ,it was (FUJI --------- V2.2A)

what more can I do ??

Thanks in advance !!

reply »