Email This Page to a Friend
Date:
October 28, 2009 01:29 PM
Author:
SWAG
Subject: AP25 HiE
Can anyone tell me the command I need to type to get into machine configuration in DOS MpM software? I want to change x/y/theta cal. settings to adjust for vision offset because I don't have the fixtures to do a calibration.
(http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=60210)
Date:
November 19, 2009 02:40 PM
Author:
AMK
Subject: AP25 HiE
We had some AP machines that are long gone but found this in an old doc. Hope this works for you.
Hit the “esc” key to get to a dos prompt
Type “edit ap.opt”
Make changes.
Save and exit.
Reboot machine
Good luck
(http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=60495)
