Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Parylene Coating

Views: 3156

#58734

Parylene Coating | 5 May, 2009

We recently started doing our own Parylene Coating on site. I am looking for some advise on the best way to remove the masking after coating. Is there a document anywhere that addresses this subject? Our fellow doing the coating had only about 2 weeks of training. He was told to use an Xacto blade to remove the masking, but since has changed to a scaple. Is there a better way.

reply »


Lou

#58771

Parylene Coating | 11 May, 2009

It really depends on what method you used to mask. Liquid mask, tape, rubber boots, etc. It is something most learned thru trial and error, much like running the parylene machine. It's never as easy as loading it up, turn it on and watch it go!

reply »

SMT Machines china