Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


0402 components

mark scheunemann

#1786

0402 components | 24 February, 2000

I am looking to discuss 0402 issues, specifically tombstoning/unsoldered. Any recommendations on pad size/spacing, stencil design etc would be helpful. Placement and reflow profile look good.

reply »


JAX

#1787

Re: 0402 components | 24 February, 2000

Mark, This topic has been discussed multiple time on this site. You can find almost all of them by searching the archives for tombstoning. That aside, have you look at your stencil apetures?(homeplate design).

reply »

Reflow Oven

One stop service for all SMT and PCB needs