Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.

Fuji CP43 placement

Views: 1471

Fuji CP43 placement - 05-/19-08 by aj  

Fuji CP43 placement - 05-/19-08 by Sr.Tech  

Fuji CP43 placement - 05-/19-08 by aj  

Fuji CP43 placement - 05-/19-08 by Sr.Tech  


aj

#54790

Fuji CP43 placement | 19 May, 2008

all,

The placement was off on one panel ( 4 up ) out of the batch. It was off by approx 1mm in the y-axis.

No obvious faults found with machine.

Any experience of such problem - I am guessing this is a sign of something wearing on the machine or slipping ?

all replies , greatly appreciated.

aj...

reply »


Sr.Tech

#54792

Fuji CP43 placement | 19 May, 2008

AJ.
The mechanical clamping units on the xyz table are notorious for slipping on these machines.

reply »


aj

#54793

Fuji CP43 placement | 19 May, 2008

can they be tightened

thanks,

reply »


Sr.Tech

#54794

Fuji CP43 placement | 19 May, 2008

Usually they can be fixed. The clamping brakes get flat spots worn on them.(Replace them) The table frame itself can get grooves worn in it as well. In that case you will need to get creative..a new frame could get pricey.

I am not saying that this is your problem, but it is definitely a place to start.

reply »

In-Circuit Test
Now Online

276
Visitors

4
Members

Featured Companies