Mirtec AOI Max Component Height

Subscribe to Thread

Has anyone tried to increase the working height on their Mir... - Apr 23, 2008 by MikeS

Did you ask Mirtec? When we were ready to buy a Mirtec they... - Apr 23, 2008 by jdengler

There is a field retrofit to increase the 25mm (0.98425") st... - Apr 24, 2008 by PeteC

I was needing to go over 1.77" for a few assemblies. ... - Apr 24, 2008 by MikeS

AOI stands for Automatic Optical Inspection doesn't it? I ap... - Apr 24, 2008 by FredC

You can adjust to 45mm clearance, But I would recommend stay... - Apr 29, 2008 by SYS-STEVEN

MikeS

#54462

Mirtec AOI Max Component Height | 23 April, 2008

Has anyone tried to increase the working height on their Mirtec AOI. We have several MV-2HTL machines and have a few boards that are over 2" tall. I'd rather not leave the parts out and have a secondary step to install them after inspection. I've got a few ideas but thought I'd inquire about workarounds from Mirtec users.

reply »

jdengler

#54464

Mirtec AOI Max Component Height | 23 April, 2008

Did you ask Mirtec? When we were ready to buy a Mirtec they asked if we needed more than normal clearance height. I do not know if this would be retrofitable but maybe you could ask.

Jerry

reply »

PeteC

#54482

Mirtec AOI Max Component Height | 24 April, 2008

There is a field retrofit to increase the 25mm (0.98425") standard clearance up to 45mm (1.77165"), its not quite the 2", but close. You will have to recreate your component library though. For more details, contact Mirtec tech support at http://www.mirtecusa.com

reply »

MikeS

#54483

Mirtec AOI Max Component Height | 24 April, 2008

I was needing to go over 1.77" for a few assemblies.

reply »

FredC

#54487

Mirtec AOI Max Component Height | 24 April, 2008

AOI stands for Automatic Optical Inspection doesn't it? I apologize for my ignorance on the original comment.

reply »

SYS-STEVEN