Forum: SMT Production & Design
Thread: Reflow Profile Design
Date: June 16, 2007 07:48 AM
Author: Grant
Subject: Reflow Profile Design
Hi,
We are using emerson gold, and I have not seen any evidence of black pad, as the pads are clean and gold colored when the part comes off. That is what worried me, as I would have thought that if the solder melted correctly, it would have stuck to the pad better than this, and taken the gold with it if the part was sheered off?
Regards,
Grant
(http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=50697)