Forum: SMT Production & Design
Thread: CP4 jerks all axis after power up and reset sw...
Date: April 12, 2012 05:49 PM
Author: Rodrigo
Subject: CP4 jerks all axis after power up and reset sw...
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30.
I was able to boot into mechanical mode at one point but now I can not do that either.
This thing is driving me crazy. Most of the time there is a logic to the errors... this time it looks like it is just ... crazy.
Thanks
(http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=66150)