Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 1533
We have MY9 - when it changes hydra tooltips - most of the t... - Mar 28, 2024 by Wade Arral
From the error message, might have to do with the "Z&qu... - Mar 28, 2024 by Thomas
In calibration menu - I see coarse measurement of z unit off... - Mar 28, 2024 by Wade Arral
Since you only saying it's the hydra error, then only run th... - Mar 28, 2024 by Thomas
For the hydra camera z-level - there is short section in man... - Mar 28, 2024 by Wade Arral
It's been long time, me memories are fading away. If I reme... - Mar 28, 2024 by Thomas
The tapping noise is what you hear when Hydra taps each tool... - Mar 28, 2024 by AlexV
Hi all - my problem is a bit worse now - I can get all hydra... - Apr 02, 2024 by Wade Arral
I believe you need one of this https://www.pfipartsus.com/pr... - Apr 02, 2024 by Thomas
You'll need the specific Mydata part. It has some specific d... - Apr 02, 2024 by MistrThou
Yes very good - thank you, I'm getting the specific hydra to... - Apr 02, 2024 by Wade Arral
Nice. BTW, I found a pic online. https://www.flasonsmt.com/... - Apr 02, 2024 by MistrThou
Hello all - so I got in the calibrate plate for hydra tool o... - Apr 08, 2024 by Wade Arral
To me, it seems like there are slightly XY offset. Hydra mig... - Apr 08, 2024 by Thomas
The error is: MOT-Command/205: Motor speed out of control Mo... - Apr 08, 2024 by MistrThou
Hi all - all good info thanks, so my indicator levels are a ... - Apr 08, 2024 by Wade Arral
I found a 0.9mm hex tool - but if I adjust the indicators &q... - Apr 08, 2024 by Wade Arral
We had a Mycronic tech in adjusting rings to get us within s... - Apr 08, 2024 by MistrThou