| Hello! SMT professionals, | | I do not know if anyone posted this question before. | Last week, I reflowed our newly designed thin Rigid-Flex pcb with 0.040" thickness. I found all of pins of a TQFP48 ic did not get wetted. I could see on the heel side of pin foot there is a clear unwetting line between pin and solder. Other components including bigger IC and heavy thermal mass parts on the board are soldered very good. I found this TQFP48 is made by Texas Instruments, and is Palladium Plated leads. | | Does anyone have this unwetting problem on Palladium Plated leads? How do you solve the problem? I thank for any help, advise and suggestion you could give. | | By the way, I am using a Vitronics Unitherm520 air convection oven with 5 heat zone. The profile gets peak temp. of 225 degree c. | | Regards, | | Dennis | Dennis, Palladium requires a higher reflow temperature to solder well. However, I suggest you check the activity of your flux system to make sure it has enough "muscle" to solder the palladium. It should. Typically, a 15 degree increase is enough to get good solderability. Also, make sure the paste used to solder that device wasn't past its' stencil life. If the paste was on the stencil too long, the flux would have evaporated enough that there wasn't a sufficient amount to solder the palladium but the tin/lead would still reflow fine.
Regards, Justin Medernach
reply »