Mydata TP11-UFP F-MOT1-38/245

Subscribe to Thread

Hello, I have a Mydata TP11-UFP which stopped working. It p... - Oct 24, 2021 by Artem

The 245 error is with your x belt motor not the x wagon moto... - Oct 25, 2021 by bruce

I just got the same machine with very low hours. What has b... - Oct 26, 2021 by smtUSA

Hello, I have found the problem. The capacitors on the PAIB... - Oct 29, 2021 by Artem

Artem

#87226

Mydata TP11-UFP F-MOT1-38/245 | 24 October, 2021

Hello,

I have a Mydata TP11-UFP which stopped working. It prints F-MOT1-38/245:MSETDYNX during initialisation. Any idea what could be wrong?

I have already replaced the capacitors and the Inrush Current Limiters on the "L-19-588-18" board. Also installed new contactors for the X-Motor and replaced the "ELMO module". Swapping the MOT cards does not change anything.

Thanks, Artem

reply »

bruce

#87227

Mydata TP11-UFP F-MOT1-38/245 | 25 October, 2021

The 245 error is with your x belt motor not the x wagon motor. double check all the fuses on the back of the machine where your power comes in there should be 3 of them. if you haven't changed your blue cables in a while I would change those out. your PAIB board may also be bad.

reply »

smtUSA

#87234

Mydata TP11-UFP F-MOT1-38/245 | 26 October, 2021

I just got the same machine with very low hours. What has been your experience? This is my first mydata machine.

reply »

Artem

#87247

Mydata TP11-UFP F-MOT1-38/245 | 29 October, 2021

Hello,

I have found the problem. The capacitors on the PAIB board were leaking. They have even demaged some traces and vias on the PCB and the -5V supply on the PAIB board was not working anymore. Got it working again :)

reply »