Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 7377
Background on the PCB: Thickness: .032" Material: Standard F... - Jun 02, 2014 by Clydestrum
Check out the set up of Depanelizer. Try to cut at slower sp... - Jun 03, 2014 by Daxa
Incoming inspection: Look for flaws and measure position of... - Jun 03, 2014 by SWAG
Yes, unfortunately I was alerted to this problem at QC. (whi... - Jun 03, 2014 by Clydestrum
Maybe the V-Score is not deep enough? I am used to seeing... - Jun 03, 2014 by Hegemon
Well, we cannot make the cuts any deeper as then we would in... - Jun 04, 2014 by Clydestrum
> Well, we cannot make the cuts any deeper as then >... - Jun 04, 2014 by Hegemon
Can you cut v-scores deeper to resolve the issue then build ... - Jun 05, 2014 by SWAG
SWAG has it. Carriers for SMT are a great idea, especially ... - Jun 06, 2014 by Hegemon
Well, typically we put rails on a lot of the boards due to t... - Jun 09, 2014 by Clydestrum
We had a similar problem once, it was due to insufficient v-... - Jun 10, 2014 by Comatose
I didn't even think of running a blade down those scores. I ... - Jun 12, 2014 by Clydestrum
Deepening the V-scores was in vain. No change. This board is... - Jun 12, 2014 by Clydestrum
I did not see any mention on the inner layer setback. We us... - Jun 13, 2014 by esoderberg